Topics covered in this article:
- How do I turn on the Halo Collar?
- How do I turn off the Halo Collar?
NOTE: We strongly recommend that you remove the Halo Collar from your dog before turning the Halo Collar on or off. This is to prevent the vibrations that are used to confirm the collar power status from confusing your dog - where these same vibrations are used as part of their training. However, you can use a short press on the collar to confirm if it is on while your dog is wearing it.
To power the Halo Collar ON: Press and briefly hold the Power button for 1-2 seconds—and release. Note: while you are pressing the button, the battery LED will rapidly blink GREEN, YELLOW or RED - indicating the current charge level. If the collar was OFF, then this short press will cause the collar to vibrate once. While the Halo Collar is ON and the collar is moving, the logo LED light will blink in that pet's color. The collar is now awake from low-power mode and ready to function normally. See the figure below.
To power the Halo Collar OFF: Make sure the collar is resting, with the USB port facing up (as in, the collar is upside down). Turning the collar off will only work if it is in this position, unless it is plugged in to power (see note below). The reason for this is to avoid your dog inadvertently turning the collar off. Once it is in this position, press and hold the power button for about 6 seconds, until you feel three short vibrations. Then, release the button and note that Logo LED light flashes red and - after a few seconds - goes out. The collar is now in very low power mode.
Note: When the collar is plugged in to its USB charger, it can be turned off while in any orientation. This is because the dog cannot inadvertently turn the collar off when it is plugged into the charger.
Also: This mode is only intended for wired updates and for saving battery when you have no way to charge the Halo Collar; it should NOT be used while on your dog.
Turning the Halo Collar OFF so you can begin a firmware update via USB: If you need to connect to your collar via USB, first connect your collar to your PC using the provided USB-C cable. Then, turn the collar OFF using the instructions above. Once the collar is OFF, its internal Flash drive becomes accessible on your PC.