How to Replace the Halo Collar Strap With My Own Collar Strap Follow
Each Halo Collar ships with a Halo strap made from an easy-to-clean, extremely durable material that won't retain water, smells, or bacteria. However, if you wish to use your own collar or strap, follow the steps below.
- After installation, a snap- or clip-style strap will not be easily adjustable.
- If your collar has a Halo Pro Case, you will need to remove the Pro Case in order to change the strap.
- To remove the Pro Case, simply undo the Velcro fasteners and carefully remove the case. There is no need to undo anything on the Halo Collar itself.
- Once you follow the steps below to change the strap, replace the Pro Case on your collar and re-fasten the velcro to secure it.
How is it done?
- Fit and adjust the provided snap/clip-style strap to your dog’s neck before starting. If a Halo Collar was already installed on the strap, follow steps 2-4 to remove it first.
- Unscrew and remove – but keep - the Halo Collar’s installed contact tips. You will need these in step 8.
- Open the two Retention Loops by unscrewing the two thumb screws and releasing that end of each loop.
- Remove the Halo strap carefully from each retention loop
- Using the Halo strap as a guide, punch two retention holes in your own collar. The location of these holes should be at the same positions as on the Halo strap—as measured from the buckle-end.
- NOTE: This typically requires punching each hole through two layers of your snap- or clip-type strap. If so, the ‘snap/clip-style’ strap will not be adjustable.
- Slide the new strap in place and align the two retention holes with the contact tip locations on the Halo Collar.
- Close and secure the each of the retention loops around the strap by closing the loop and hand-tightening each thumb screw.
- Screw both of the original contact tips through the strap into the the Halo Collar.
If you wish to replace the provided strap with a belt-buckle strap, follow these steps:
- Fit and adjust the provided snap/clip-style strap to your dog’s neck before starting. (If a Halo Collar was already installed on the strap, follow steps 2-4 to remove it first)
- Unscrew and remove – but keep - the Halo Collar’s installed contact tips. You will need these in step 8.
- Open the two Retention Loops by unscrewing the two thumb screws and releasing that end of each loop.
- Remove the Halo strap carefully from each retention loop and re-tighten the Retention Loops (finger-tight only).
- Using the provided Halo strap as a guide, punch two (2) retention holes in your own collar. The location of these holes should be at the same positions as on the Halo strap—as measured from the buckle-end.
- Slide the new strap through the retention loops until the two retention holes align with the contact tip locations on the Halo Collar.
- Screw both of the original contact tips through the strap into the the Halo Collar.
Comments
0 comments
Article is closed for comments.